Sears 61011 Manual De Uso página 41

C if it is This Regulator:
Gas flow
Do not
remove this
protective cap
except for
conversion
Lever shown closed
PULL TO OPEN _Assembly
_.I_. "7">... Gas flow
into range
Lever shown dosed_ _,r_'-_.-['__ _>5_,._1)"
PULL TO OPEN ..."f [.E_.:'/_ _ (Some of these
,,"x egu,.to be
"_ _ range inthis way)
1. Unscrew the plastic-protected hex-nut cap from the
regulator°
2. Carefully pry the protective plastic cap off the
threaded metal cap. Gently pull the plastic washer
off the threads on the other side of the metal cap,
3. Push the plastic cap onto the end of the metal cap
displaying the type of' gas you are converting to.
Press the attached plastic washer onto the threads on
the other side of the metal cap,
4. Screw the hex-nut cap back into the regulator,
Do not overtighten,
STEP 2
Convert the Surface Burners
Follow the directions in A fbr Sealed Burner Models
(models without lift-up cooktops) or B for Standard
Twin Burner Models (models with lift-up cooktops).
A Sealed Burner Models
(models without lift-up cooktops)
Burner Cap
Burner Head
Screws
Burner Base " "_
Gas inlet Tube
4t
I. Remove the grates, burner caps and burner heads.
2. Using the Torxdriver, remove the burner bases by
unscrewing the 3 small screws in each base_
Lift the burner straight out.
DO NOT disconnect the wires from the burner
bases unless the cooktop needs to be raised_
25,Remove the brass orifice spud under each burner
base by unscrewing the spud flora the fitting with a
7 mm or small adjustable wrench (depending on the
size of your spuds), Apply a 3/4" wrench to the hex
on the gas inlet tube as a back-up when removing
the spud to prevent the aluminum tube from
twisting.
4. Install the orifice spuds according to one of
the following diagrams (see [_] or [_) for LP gas
or natural gas, depending on which you are
converting to.
[_ Orifice Spuds for Converting to LP Gas:
LP orifice spuds are in a ' -'
small plastic bag _ _
packed with this Use
and Care Manual° LP
orifice spuds have a 2- Front of
digit number and the
letter "L" on one side. Each orifice spud will also have
1 or 2 grooves on one side, denoting the location on
the range where it is to be installed as shown above.
[_] Orifice Spuds for Converting to Natural Gas:
Natural gas orifice spuds r- -_
have a 3-digit number _ R_
on one side. Each
orifice spud will also
have 1, 2 or 3 grooves _ _ of
on one side, with the
letter "N" underneath denoting the location on the
range where it is to be installed as shown above.
5. To prevent leakage, make sure the orifice spuds are
securely screwed into the gas inlet tubes. Use a small
wrench to hold the inlet tube hex to prevent it from
twisting.
6. Put old orifice spuds back in the bag to save for
possible future conversion,
(continued next page)