Sears 61011 Manual De Uso página 42

Converting to LP Gas (continued)
NOTE: If an orifice spud is
accidentally dropped, the cooktop
can be raised by disengaging the
2 front clips with a large flat
blade screwdriver.
DO NOT attempt to raise the cooktop without
removing all 4 burner bases.
If wires were disconnected to remove the cooktop, feed
wires through the burner holes in the cooktop° Attach
to each burner electrode terminal carefully, making
sure not to bend the termina!° Then lower cooktop
until it snaps over the clips.
7. Carefully insert
burner bases
straight down with
the tube over the
orifice spud° Replace the screws, making sure the tall
screw is opposite the burner electrode in each
burner base°
B Standard Twin Burner Models
(models with lift-up cooktops)
1. Lift the cooktop.
2. Lift the burner
assemblies
straight up and
set aside to gain
access to surface
burner spuds.
3. With a 7 mm,
5/16" or a small "_[[_
adjustable
wrench (depending on the size needed), remove each
of the four spuds on the surface burner gas inlet tubes
and replace them with the correct gas spuds mounted
in a holder at the right rear of the range, above the
regulator. Natural gas spuds are brass and LP gas
spuds are red or silver. (Mount the spuds that you
removed from the inlet tubes back in the holder_)
To prevent leakage, make sure spuds are securely
screwed into gas inlet tubes,
4. Replace the burner assemblies.
5. Keep all spuds with your range so you have them if
you move or get a different gas hook-up
.... T op Bumer Orifice Drill Size Color
Natural Gas #54 (.0550 Dia.) Brass
Lp (Propane) #66 (_0330 Dia.,) Red or Silver
STEP 3
Convert Oven Thermostat
(for models equipped with Standing Pilots)
1. Remove the OVEN CONTROL knob°
2. Locate the gas selector screw at
the left of the thermostat shaft.
Turn the screw until the small
pointer stops at LP or N,
depending on the type of gas you
are converting to, The most the
screw will move is 1t2 a turn.
3. Replace the OVEN CONTROL knob.
STEP 4
Convert the Oven Burner Orifice
2t
Remove oven door, storage drawer or broiler drawer
and oven bottom. The lower burner orifice spud is
located behind the storage drawer, broiler drawer or
kick panel. (On some models, a metal shield must
be removed to access the orifice.)
To convert to LP gas, use a
I/2" wrench to turn the lower
burner orifice spud clockwise.
Tighten the spud only until it is
snug. To prevent damage, do
not overtighten the spud.
To convert to natural gas, loosen the spud about
two turns,
42