Sears 61011 Manual De Uso página 39

STEP I 0
installing the Anti-Tip Device
WARNING:
. Range must be secured with an approved Anti-
Tip device.
• Unless properly installed, the _ange could be
tipped by you or a child standing, sitting or
leaning on an open door
• After installing the Anti-Tip device, verify that it
is in place by carefiatly attempting to tilt the range
forward.
• This range has been designed to meet all recognized
industry tip standards for all norma! conditions
• The use of this device does not preclude tipping
of the range when not properly installed.
• If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB02X7909.
I. Mark the wall where the RIGHT EDGE of the
range is to be located° Be sure to allow for the
countertop overhang if you intend to install the
range next to cabinets.
Anti-Tip
I_ 11 device I
Slotted I+',L__._.. 1
head
Ill Wal_p -F__
screw late 1
Approx 20' ,.__,
W' _-//
/ (5.4 cm) /-" Marked edge of range
2. Locate the outside edge of the device 2¼" (5.4 cm)
toward the center of the range from the marked
edge of the range,
3. Using the device as a template, mark the position of
the hole for the screw.
4. For wood construction, drill a pilot hole at an angle
of 20 degrees from the horizontal. A nail or awl may
be used if a drill is not available
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you wi!l need a
1/4" x 1_" lag bolt and a 112" OoD. sleeve anchor,
-which are not provided. Drill the recommended size
hole for the hardware.
Install the sleeve anchor into the drilled hole and then
install the tag bolt through the device_ The bolts must
be properly tightened as recommended for the hardware°
Wallboard
Anti-Tip
device
Back of range
Wood screw
5. Slide the range against the walt, and check for
proper installation by grasping the front edges of the
rear surface unit openings and carefiflly attempting
to tilt the range forward.
WHEN ALL HOOKUPS ARE COMPLETED:
MAKE SURE ALL OF THE CONTROLS ARE
LEEr IN THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
39