Operation Buttons - Singer 7258 Manual De Instrucciones

OPERATION BUTTONS
Reverse stitch button
Bouton du point de marche arriere
_(._o Bot6n de puntada hacia atras
i\_cJ-__ _ Programmable needle up/down button
,, _
Touche de position d'arr@t d'aiguitte
Nterruptor de posicion de aguja parada
Start/stop button
Bouton de marche/arr6t
Bot6n inicio/parada
START/STOP BUTTON
When sewing without having the foot controller connected, the machine starts slowly when the start/stop button is pushed. When
it is pushed again, needle moves and stops at its highest position.
When using foot control, simply press foot pedal with your foot until you reach a slow even speed. The harder you push, the faster
the machine will sew. Release pressure on foot pedal to stop the machine.
I NOTE: When foot control is connected, start/stop button cannot be used. I
I
PROGRAMMABLE NEEDLE UP/DOWN BUTTON ((_)
Push the switch and LED lamp will be lit red and needle will stop at down position whenever you stop sewing.
Push it again to stop needle at up position.
DUAL PURPOSE REVERSE/TACKING STITCH
BUTTON
* Reverse stitch function for straight and zigzag stitches ( _
)
Reverse sewing is carried out while the reverse stitch button
is pushed.
The machine will continue to sew in reverse as long as the
reverse button is pressed.
Tacking stitch function for tie-off of other stitches ( IMI)
The sewing machine makes 4 tiny tacking stitches to tie
off the sewing on all patterns except straight, zigzag and
buttonhole stitches. The position of the tacking stitches wilt
be at the exact spot in the pattern where the reverse/tacking
stitch button is pushed.
NOTE: This function is very useful for tying off the
sewing pattern to avoid raveling at the start and end
of sewing.
34