CASUALPLAY S4 Instrucciones De Uso página 13

on the mat as shown in the photo (fig. 21).
• Assemble the protectors by fastening the velcro. The chest protectors should be
positioned so that the stitching does not come into contact with the child (fig. 22).
Adjusting the handlebar (see illustrations 23 - 24)
• To adjust the handlebar press the button in the middle (fig. 23) and place it in the
position you wish (fig. 24).
Adjusting the hood (see illustrations 25 - 26)
• Press the button to release the hood (fig. 25).
• Insert the straps of the hood inside the plastic guides (fig. 26).
• Open the hood by pulling it outwards.
• Once the hood is open, fasten it by pressing down on the buckles located on the
either side.
Fatting the raincover (see illustrations 27 - 29)
• Place the rain cover over the child's seat in a very careful manner (fig. 27 - 28) by
using the zip located on the hood (fig. 29). Adjust the top part of the cover to the
footrest using the Velcro straps.
how to remove the seat cover (Mod. S4/S6) (see illustrations 30 - 35)
• Remove the hood (fig. 30).
• Remove the plastic part by pressing in the direction of the arrow (fig. 31).
• Release the back of the chassis by pulling to one side (fig. 32).
• Remove the hooks from the seat cover (fig. 33 - 34).
• Remove the buckle (fig. 35).
Folding the pushchair (see illustrations 36 - 40)
• Pull the back of the seat to upright position.
• Unclip the safety locks (fig. 36).
• Lift the catch positioned on the back of the left leg as looking from the rear (fig. 37).
• With the brake on and the hood in a closed position, push down on the handle bar
until the pushchair is in the position shown (fig. 38).
• Close the safety catch (fig. 39 - 40).
UNISYSTEM
• This exclusive fastener system means that the S4, S6 pushchairs can be used
with the following complements: Prima, Mako, Playmoon and Baby Zero Plus.
11