4 Transport and storage
4.1 General Remarks
If changes are to be made to the filter unit, it may be sensible to have the conversion
work on it done at KEMPER GmbH. For this, the filter unit must be transported back
to KEMPER GmbH.
DANGER
Potentially fatal crushing injuries when lifting and transporting
the individual components of the filter unit
Incorrect lifting and transporting of the components of the filter
unit may cause them to tilt and fall over.
Only lift and transport the components of the filter unit with an
individual forklift! You must not exceed the permitted load
capacity of the forklift.
Never stand under suspended loads!
Part no.: 150 2627 (CAT 2.0)
All rights over changes without prior notice and errors reserved.
KEMPER CleanAirTower 2.0 Operating instructions - EN
- 56 -
Rev.: 00
Issue: 02/2017