Kemper Clean Air Tower Manual De Uso página 66

- Service socket (item 5)
Connectivity for the KEMPER service. KEMPER service can use this interface
to carry out maintenance.
- "Differential pressure" measuring point (item 6)
Only to be used by KEMPER-Service.
- Signal horn (item 7)
Safe collection of dust and smoke is only possible with sufficient suction
performance. With increasing dust load to the filter elements, the flow
resistance increases and the suction performance decreases. As soon as a
minimal value is reached, the alarm horn sounds at regular intervals.
- External connections (item 8)
Optional.
NOTE
When first connecting the filter system to the power mains, a self-test
will be conducted, the alarm horn will sound for a short time and the
signal lamps will blink. This should be carried out in regular intervals
(weekly) by the user by pulling out and then plugging the mains plug
back in again. If the alarm horn or signal lights doe not activate at this
time, the filter systemshould be checked by KEMPER-Service.
Part no.: 150 2627 (CAT 2.0)
All rights over changes without prior notice and errors reserved.
KEMPER CleanAirTower 2.0 Operating instructions - EN
- 66 - Rev.: 00
Issue: 02/2017