Transport With Forklift; Storage - Kemper Clean Air Tower Manual De Uso

4.3 Transport with forklift

DANGER
Potentially fatal crushing injuries when transporting components of
the filter unit!
Incorrect lifting and transport can cause the components of the
filter unit to tilt and fall over!
Never stand under suspended loads!
●
The components of the filter unit must be transported
●
individually and, at the same time, lashed securely to the forklift
to avoid the danger of tilting and falling over.
The following forklifts are approved for transporting components of the filter unit:
Roll pallets of the transport system with transport vehicle,
–
forklifts and
–
− pallet truck.
Information
Prevent components of the filter unit from coming into contact with the lifting
frame of the forklift:
If need be, to achieve this place wooden spacers between fan, filter and
●
suction components and the lifting frame.
Avoid severe impacts when putting down components
●
of the filter system.
Comply with max. load capacity of the industrial truck.
●

4.4 Storage

Components of the filter unit are to be stored in a clean and dry place in their original
packaging at an ambient temperature of between 0°C and +55°C. Components of the
filter unit must not be loaded by other objects.
Part no.: 150 2627 (CAT 2.0)
All rights over changes without prior notice and errors reserved.
KEMPER CleanAirTower 2.0 Operating instructions - EN
- 58 - Rev.: 00
Issue: 02/2017