Zgonc Twister 4800 D Manual De Instrucciones página 10

Important:
Before using the compressor, always read the instructions manual
G
and consult it if you have any doubts regarding compressor functioning
B
Important:
safety goggles MUST be worn when using the compressor
Warning:
certain parts of the compressor may become very hot
Warning:
To avoid risks of electric shock, always use sockets with a ground connection
THINGS
• Never direct the jet of air towards persons, animals or your
body. (Always wear safety goggles to protect your eyes
from flying objects that may be lifted by the jet).
• Never direct the jet of liquids sprayed by tools connected
to the compressor towards the compressor.
• Never use the appliance in your bare feet or with wet han-
ds or feet.
• Never pull the power cable to pull the plug out of the soc-
ket or to move the compressor.
• Never leave the appliance exposed to adverse weather
conditions (rain, sun, fog, snow).
• Never transport the compressor with the reservoir pressu-
rized
• Never weld or machine the reservoir. In the case of faults
or corrosion, replace it completely.
• Never allow inexpert persons to use the compressor. Keep
children and animals away from the work area.
• Never position flammable or nylon or fabric articles close
to and/or on the compressor.
• Never clean the compressor with flammable liquids or sol-
vents. Clean with a damp cloth only, after making sure
that you have unplugged the compressor.
• The compressor is designed only to compress air and must
not be used for any other type of gas.
• The compressed air produced by the compressor cannot
not be used for pharmaceutical, food or hospital purposes
except after particular treatments. It is not suitable for fil-
ling the air bottles of scuba divers.
• Never use the compressor without guards (belt guard) and
never touch moving parts.
BELT-DRIVEN ELECTRIC COMPRESSOR
PRECAUTIONS
NOT
TO DO
THINGS TO DO
• The compressor must be used in a suitable envi-
ronment (well ventilated with an ambient tempe-
rature of between +5°C and +40°C) and never in
places affected by dust, acids, vapors, explosive or
flammable gases.
• Always maintain a safety distance of at least 4 meters
between the compressor and the work area.
• Any coloring of the belt guards of the compressor du-
ring painting operations indicates that the distance is too
short.
• Insert the plug of the electric cable in a socket of suitable
shape, voltage and frequency complying with current re-
gulations.
• For 3-phase versions, have the plug fitted by a qualified
electrician according to local regulations.
• When starting the compressor for the first time, check the
correct direction of rotation and that this matches the di-
rection indicated by the arrow on the belt guard (versions
with plastic protection) or on the motor (versions with
metal protection).
• Use extension cables with a maximum length of 5 meters
and of suitable cross-section. The use of extension cables
of different length and also of adapters and multiple soc-
kets should be avoided.
• Always use the switch of the pressure switch to switch off
the compressor or use the switch of the electric panel for
models equipped with this. Never switch off the compres-
sor by pulling out the plug in order to avoid restart with
pressure in the head.
• Always use the handle to move the compressor.
• When operating, the compressor must be placed on a sta-
ble, horizontal surface to guarantee correct lubrication.
• Position the compressor at least 50 cm from the wall to
permit optimal circulation of fresh air and to guarantee
correct cooling.
10