Fuse Replacement; Mower Adjustments; Gauge Wheels - Snapper LT23420 Manual Del Operador

MaJflteflaflce
Fuse Replacement
Service Interval: As Required
The fuse is a 20-amp blade type automotive fuse located
behind the battery on the steering tower. Replace only
with the same rated fuse, 20=amp.
1. Open the hood and locate the fuse holder (B, Figure
23) and fuse (A). Attached to the steering tower.
2. Hold the fuse holder (B) and pull out the fuse (A).
3. Inspect the fuse for a broken connection (see Figure
24). Replace fuse if connection is broken. If you are
not sure if connection is broken replace fuse.
4. Hold the fuse holder (B) and insert new fuse (A) until
it is seated properly.
Figure 23. Fuse
Mower Adjustments
Gauge Wheels
Service Interval: As Required
The mower gauge wheels can be placed in two positions
depending on the height of cut. When using higher cut-
ting heights, set the wheels in the lower position. When
using lower cutting heights, set the wheels in the upper
position. Do not allow wheels to remain on the ground
constantly while mowing. To adjust:
1. Remove the Iocknut (B, Figure 25), gauge wheel (C),
washers (D), and shoulder bolt (E). Change position
of gauge wheel to desired height.
2. Insert shoulder bolt (E) through washers (D) gauge
wheel (C), and gauge wheel bracket (A). Secure with
Iocknut (B). Repeat Steps 1 & 2 for all gauge wheels.
Solid Fusible Link
Broken Fusible Link
======_ =,%
--j
Figure 25. Fixed Bracket Gauge Wheel Adjustment
Figure 24. Blade Type Fuse
25