Before Initial Start-Up; Engine Oil; Oil Considerations; Battery Connection - Briggs & Stratton 190839GS Manual Del Propietário

Ocultar thumbs Ver también para 190839GS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

P, r iggs & Stratton Power Products Home Generator
System
Owners
Manual
BEFORE
INITIAL
START-UP
Engine
Oil
This engine is shipped from the factory filled with the
recommended oil. Before starting the engine, check oil level
and ensure that engine is serviced as described in the
engine
owner's
manua[,
_b
CAUTION!
Any attempt to crank or start the
engine before it has been properly serviced with the
recommended oil will result in an engine failure that
is not covered under warranty.
Oil
Considerations
Your Home
Generator
System
is equipped with an engine
that has been pre-run
at the factory
and does not require
the traditional
"break-in"
procedure.
In order to provide a greater'"backup"
capability, the
system
is filled with
synthetic
oil (API SJ/CF SW-30W).This
allows
for system operation
in the widest
range of
temperature
and climate conditions.
NOTE:
The use of synthetic
oil DOES
NOT
alter the
required
oil change intervals described
in the engine
owner's
manual.
Battery
Connection
The Home Generator System is supplied with a 12Volt DC
18 Amp-Hour
sealed rechargeable battery. It is installed in
the unit and the battery cables are connected at the
factory.The unit's 15 Amp fuse has been removed for
shipping (this prevents the unit from starting).
CAUTION!
Do Not install the ISAmp fuse until
all plumbing and wiring has been completed and
inspected. Failure to install the fuse as described in
the Installation Manual could cause the engine to
start.
NOTE: With the battery installed, utility power supplied to
the Automatic Transfer Switch, and the unit in AUTO mode,
the battery receives a trickle charge while the engine is not
running.The trickle charger cannot be used to recharge a
battery that is completely discharged.
Gaseous
Fuel System
• Ensure that all fuel pipe connections are tight, secure and
without
leaks.
• Ensure that all shutoff valves are OPEN and that
adequate pressure is available.
If you smell 'raw' gaseous fuel (natural or LP) near the unit,
immediately turn off the gas supply to the generator.
Contact your gas utility or the system installer for
assistance in determining the source of the smell.
The AUTO/OFF/MANUAL
Switch
This three-position
device is referred to herein as
"AUTO/OFF/MANUAL".
It is found on the control panel, as
shown earlier, and is used as follows:
• "AUTO"
position is the normal operating position. If a
utility power outage is sensed, the system will start the
generator, let it reach stable operating speed, then
connect generator power to the transfer switch.
When utility power is restored, the system reconnects
utility power to the transfer switch, lett the engine 'cool
down', shuts off the generator, and wait_ for the next
utility power outage.
• "OFF"
position turns off a running generator, takes the
system out of Automatic
mode and resets faults.The unit
will not exercise, but the 'Set Exercise' setting is not IosL
• "MANUAL"
position starts the engine but does not
disconnect utility power from the transfer switch. It is
used for maintenance or diagnostic functions.
,_
CAUTION!
With the switch set to AUTO, the
engine may crank and start at any time without
warning. Such automatic starting normally occurs
when utility source voltage drops below a preset
level or during the normal exercise cycle.To prevent
possible injury that might be caused by such sudden
starts, always set the AUTO/OFF/MANUAL
switch
to OFF and remove the ISAmp fuse before
working on or around the generator or transfer
switch.
The other controls and devices installed on the control
panel are described on page I I,"KnowYour
System
Control Panel".
13

Publicidad

Tabla de contenido
loading

Tabla de contenido