• Warning: When the sandwich maker
is switched on, the inside surfaces can
reach extremely high temperatures and
can cause serious burns. Do not touch
the appliance while it is switched on. Use
the handles to move or adjust its position.
• Do not pull on the electric cable in order
to unplug the appliance.
• Do not leave the appliance unattended
while switched on and keep it well out of
the reach of children or disabled people.
• Do not let the cable come into contact
with parts of the appliance that may be
hot.
• Never use an electric appliance whose
cable or plug are in less than perfect
condition. Never use an appliance that
is not working properly or has been
damaged in any way. Take the appliance
to an authorised technical service centre
to be examined, repaired or adjusted.
If the cable is damaged, contact an
authorised Technical Assistance Centre
who will replace it.
• In the case of technical failure and/
or imperfect working, switch off the
appliance and do not attempt to repair
it. Contact an authorised Technical
Assistance Centre and ask them to
use original replacement parts and
accessories.
• If you decide to dispose of the appliance
definitively, it is advisable to cut the
electric cable after first ensuring that the
appliance is unplugged.
• Do not use metallic utensils on the hot
surfaces as this can damage their special
non-stick coating.
• This appliance should not be used
by physically, sensorially or mentally
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance by
a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
• For greater protection, we recommend
installing a residual current device (RCD)
with an operational residual current not
exceeding 30 mA. Ask your installer for
advice.
4. BEFORE USING FOR
THE FIRST TIME
Before using the appliance for the first time:
• Clean the inside surfaces with a damp
cloth and leave to dry.
• When the inside surfaces are dry, grease
them lightly with vegetable oil.
5. TO USE
MOD. SW-220/ SW-420
1. Place the appliance on a stable surface,
leaving sufficient room around the edges
and plug it in with the lid closed. The
red pilot light will come on.
2. Prepare the ingredients you wish to
toast. For each sandwich you will
need two slices of bread plus their
corresponding filling. To achieve a
golden brown toasting lightly butter the
bread on the side that will be in contact
with the hot surfaces.
3. After about 5 minutes, the green pilot
light will come on to indicate that
the plates have reached the correct
temperature for toasting. During
toasting, the green pilot light will switch
on and off at regular intervals showing
the thermostat cycles; the red pilot light
will remain constantly on to show that
the appliance is connected to the mains.
4. Lift the lid and place the sandwich(es)
in the sandwich maker taking care not
to burn your fingers. Carefully close the
lid and fasten the closure catch (F) on
the lower handle (fig.2). The sandwich
maker can toast either one or two
sandwiches.
5. After approximately 3 or 4 minutes
(depending on how well done you wish
your sandwich to be), the sandwiches
will be ready to serve. Open the lid
and carefully remove the sandwiches,
taking care not to burn your fingers.
We recommend that you use a wooden
spatula. Do not use sharp instruments
as they can damage the non-stick
coating of the inside surfaces.
10