SOMFY MAESTRIA+ 50 RTS Instrucciones página 7

E4. MANUAL ADJUSTMENT OF THE LOWER END LIMIT AND AUTOMATIC ADJUSTMENT OF THE UPPER END LIMIT WITH
AUTOMATIC CATCHING SYSTEM
The catching system at the lower end limit my vary depending on
the driven product, but the procedure for setting the entrance/exit
positions of the catches remains the same on all systems.
1) Position the driven product at its half-way position.
2) Press and hold the "Up" and "Down" buttons simultaneously for
5 seconds until a slow up and down movement.
3) Press the "Down" button: the driven product lowers.
4) Press the "my" button to stop the product at position (P1), which
corresponds to the automatic catching system's entrance point.
5) Press the "my" and "Up" buttons simultaneously: the driven product
raises and stops, putting tension on the fabric.
6) Press the "Down" button: the driven product lowers.
7) Press the "my" button to stop the driven product at position (P2),
which corresponds to the automatic catching system's exit point.
8) Press "my" until the driven product moves up and down briefly to
validate the end limit setting.
E5. MANUAL ADJUSTMENT OF END LIMITS WITH THE AUTOMATIC CATCHING SYSTEM
The catching system at the lower end limit my vary depending on
the driven product, but the procedure for setting the entrance/exit
positions of the catches remains the same on all systems.
1) Position the driven product at its half-way position.
2) Press and hold the "Up" and "Down" buttons simultaneously for
5 seconds until a slow up and down movement.
3) Press the "Up" button: the driven product raises.
4) Press "my" to stop the driven product at the upper end limit
position (if necessary, adjust the position of the driven product
using the "Up" or "Down" buttons).
5) Press the "my" and "Down" buttons simultaneously: the driven
product lowers.
6) Press the "my" button to stop the product at position (P1), which
corresponds to the automatic catching system's entrance point.
7) Press the "my" and "Up" buttons simultaneously: the driven
product raises and stops, putting tension on the fabric.
8) Press the "Down" button: the driven product lowers.
9) Press the "my" button to stop the driven product at position (P2),
which corresponds to the automatic catching system's exit point.
10) Press "my" until the driven product moves up and down briefly to
validate the end limit setting.
Copyright © 2017 Somfy SAS. All rights reserved.
1) 2)
3)
4)
P1
6)
7)
1) 2)
3)
5)
7)
9)
Non contractual images
EN
5 sec.
P1
P
P2
P
5)
P
P
P
P1
P
P2
8)
P2
5 sec.
4)
6)
P1
8)
P1
P2
10)
P2
7
1
2
1
2
1
2