Wiring; Set-Up - SOMFY MAESTRIA+ 50 RTS Instrucciones

EN

2. 2. WIRING

Cables routed through a metal internal wall must be protected and insulated by sleeving or sheathing.
Secure the cables to prevent any contact with moving parts.
If the drive is used outdoors and if the power supply cable is of the H05-VVF type, run the cable in a UV-resistant
duct, e.g. trunking.
Leave the drive power supply cable accessible: it must be easily replaceable.
Always make a loop in the power supply cable on the outside to prevent water from entering the drive.
1) Switch the power supply off.
2) Connect the drive according to the information provided in the table
below:
Neutral (N)
120 V 60 Hz
2. 3. SET UP
This guide describes only the commissioning using an RTS control point as Telis 1 RTS. For commissioning using
other RTS control point, refer to the corresponding guide.
2. 3. 1. Identification of the set-up steps already performed
Power must only be supplied to one drive at a time.
Three different reactions allow the drive status to be identified. Switch off the power for two seconds on a single
driven product to identify the drive's status:
Reaction 1:
The driven product moves up and down briefly upon power-up.
The end limits have been set and no control point is programmed.
• See section "Preprogramming of the Somfy local control point" (§
Somfy local control point" (§
Reaction 2:
The driven product does not move up and down briefly upon power-up and does not react when the buttons on the
control point are pressed.
The end limits have not been set and no control point is programmed.
• See section Preprogramming of the Somfy local control point (§
Reaction 3:
The driven product does not move up and down briefly upon power-up but reacts when the buttons on the control
point are pressed.
The set-up procedure is complete.
• To modify the advanced settings, see section "Setting advanced sections" (§
4
Cable
Hot (L)
White Black
2. 3. 6 A
).
Non contractual images
1)
Ground ( )
Green
2. 3. 2
2. 3. 2
).
Copyright © 2017 Somfy SAS. All rights reserved.
2)
OFF
L N
120 V 60 Hz
) then section "Programming of the
2. 3. 5
).