Assembly Instructions; Use; Safety Instructions On Use - zarges Z600 Manual De Instrucciones

4.2 Assembly instruc- The assembly instructions are in the form of diagrams.
tions

5. Use

5.1 Safety instructions 5.1.1. General safety instructions on use
on use
• Never leave the work platform unattended in public places. Cordon off the area
• Check the following before using the work platform:
5.1.2. Specific dangers when using the work platform
D
D
TOOLS
For step-by-step instructions for assembly, see
the illustrations section of this manual.
immediately surrounding the work platform.
> Are the stabilisers correctly attached?
> Are the brake levers on the swivel castors secured and the swivel castors clear
of the ground?
> Is the work platform standing in vertical position on even ground?
> Are both railings attached and locked in place?
> When working outdoors: Are there 3 ballast weights fitted on each stabiliser?
ANGER
ANGER OF SERIOUS OR FATAL INJURY IF THE WORK PLATFORM TOPPLES OVER OR COLLAPSES AND THROUGH FALLING MATERIALS OR
!
> Always climb onto the work platform from the inside.
> Never exceed the maximum permissible load (2.0 kN/m
> Never exceed the maximum permissible platform height
(see "3.3 Technical data").
> Never increase the platform height by using ladders, boxes or other devices.
> Never load the platform on only one side. Always distribute loads evenly on the
platform.
> Never impose horizontal loads on the work platform and never attach lifting
tackle, hoists or similar devices to it.
> Never use the work platform outdoors or in open buildings when wind speeds
exceed 12 m/s (wind strength 6 on the Beaufort scale).
> Never attach advertising placards or products which could increase the wind
load.
> If high winds occur, leave the platform immediately, move it to a wind-protected
position with the help of several other persons and secure it appropriately
against tipping over (e.g. by anchoring it).
> When using the work platform in buildings open to the wind, in buildings with-
out cladding or on the corners of buildings, keep a close eye on the wind con-
ditions and take appropriate measures where necessary to prevent the plat-
form tipping over (e.g. fit anchors).
> After completing work, move the work platform to a wind-protected position
and where necessary, secure it appropriately against tipping over (e.g. by fitting
anchors).
2
).
19