Maintenance And Servicing; Cleaning; Inspection - zarges Z600 Manual De Instrucciones

7. Maintenance and servicing

7.1 Cleaning

7.2 Inspection

22
• Clean the work platform with a solution of water and a normal household clean-
ing agent.
W
ARNING
D
ANGER OF SLIPPING ON WATER IN THE WORKING AREA
> After cleaning, thoroughly wipe dry all tread surfaces and holding devices.
N
OTE
D
ANGER OF ENVIRONMENTAL DAMAGE
> Cleaning agents must not be allowed to seep into the soil!
> Dispose of used cleaning solutions in accordance with the applicable environ-
mental regulations!
7.2.1. Deformation, nipping, cracks
Before use, check the following components for deformation, nipping and cracks:
• Chassis with swivel castors and stabilisers
• Push-up ladders
• Struts (folding struts, horizontal struts and railings)
• Platform
> If any of the above-named defects is detected in one of the components, the
work platform must not be used.
7.2.2. Correct functioning
Before using the work platform, check the following components for correct func-
tioning:
• Swivel castors (free movement and easy running of the spindles)
• Brake levers on the swivel castors (correct functioning)
• Platform flap (correct functioning)
> If any of the above-named defects is detected in one of the components, the
work platform must not be used.
7.2.3. Lubrication
Lubricate all moving parts (spindles, bearings of the swivel castors) with normal lu-
bricating oil if they are sluggish. For use in the winter, use low viscosity oil.
W
ARNING
D
ANGER OF SLIPPING ON OIL IN THE WORKING AREA
> Wipe off superfluous oil. Oil must not be allowed to reach the tread surfaces.
N
OTE
D
ANGER OF ENVIRONMENTAL DAMAGE
> Oils must not be allowed to seep into the soil!
> Dispose of cleaning rags soiled with grease in accordance with the applicable
environmental regulations!
!
!
!
!