Waste Disposal; Service And Maintenance; Power Brush; Product Disposal - Nilfisk Handy 2-in-1 Instrucciones De Manejo

become warm during charging. This is not an
abnormal sign.

5. Waste disposal

• Try to dispose the vacuumed waste as fre-
quently as possible. The dust attached to the
fi lter can cause poor vacuuming performance
and stress the motor.
• Always switch OFF the power when operating
for disposal.
1. Detach the dust container.
2. Pull out the fi lters.
3. Empty the dust container.
4. Re-install the fi lters in correct order and posi-
tion.
5. Re-install the dust container to the vacuum
unit.
Caution
Do not vacuum a lot of dust at one time and do
not vacuum large objects. May cause the suction
port to clog and loose the suction power.
Do not vacuum kerosene, petrol or butts of
smoked cigarettes. This may cause a fi re.
Dispose dust frequently in order not to damage
the product.
6. Service and
Maintenance
Always switch OFF the power and disconnect
the power plug for the battery charger from the
power outlet before starting maintenance.
6.1 Vacuum Unit, Stick Body, Charging Base
Wipe off any dirt from the product using a dry
and soft rag.
In case of stubborn dirt, clean using a soft damp
rag soaked in a water solution diluted with a little
neutral detergent and then wipe with a dry rag.
Do not use solvents like thinner, benzene, and
spray type cleaners.
6.2 Dust Container
Remove any collected dust inside the dust con-
tainer fi rst and wash using lukewarm water.
Make sure that the dust container is completely
dry before re-assembling.
6.3 Filter
Do not wash the fi lters in the washing machine.
Do not dry them using a hot air blower such as a
dryer or a hair dryer.
In case of stubborn dirt or loss in suction power,
wash as instructed below:
1. Remove the dust fi rst
2. Wash with water
3. Make sure that the fi lters are completely dry
before the parts are re-assembled.
6.4

Power Brush

Carry out the maintenance if any waste threads
or hair gets tangled in the brush.
Regular Maintenance
Slowly rotate the brush manually and remove
any foreign objects tangled around the brush.
Maintenance when the power brush cannot
be manually rotated
1. Unscrew the left hand side and then lift and
dislodge the brush cover.
2. Lift up the left side of the rotating brush and
then remove the belt from the end of the
rotating brush.
3. Take out the rotating brush and remove the
blockage. Take out the wastes.
4. Re-install the rotating brush. Finally, check
that the brush cover is securely fi xed and the
rotating brush rotates properly.

7. Product Disposal

When the battery packs will no longer hold a
charge, the product has reached the end of its
useful life.
Before discarding the product, the rechargeable
battery pack must be removed and recycled in
accordance with federal and local laws, as out-
lined below.
NOTE: The battery pack is not replaceable. After
removing the battery pack, the product must be
discarded.
1. Use a screwdriver to unscrew the housing
2. Cut the wires with scissors or wire cutters in
order to free the battery compartment from the
unit completely.
3. Take out the battery compartment with motor,
Unscrew the battery bracket.
4. Remove the battery from the unit. WARNING:
Do not mutilate or incinerate the battery pack,
as it will explode at high temperatures.
3