Safety System; Switching Off A Burner; Power Levels; Warnings - Bosch PSA326B20E Instrucciones De Funcionamiento

Safety system

Termopar

Switching off a burner

Power levels

Setting
Large flame
Economy
flame

Warnings

2. Turn the control knob to the required setting.
If it does not come on, turn the control knob to the off
setting and repeat the steps above. This time, press and
hold the control knob for longer (up to 10 seconds).
Warning! If after 15 seconds the flame does not ignite,
switch off the burner and open a nearby window or door.
Wait at least one minute before trying to switch the
burner on.
Depending on the model, your hob may have a safety
system (thermocouple) that prevents the flow of gas if
the burners accidentally switch off. To ensure that this
device is active, switch on the burner as usual and,
without releasing the control knob, press and hold it
down firmly for 4 seconds after lighting the flame.
Ignition sparker
Turn the corresponding control knob clockwise to the 0
setting.
The progressive control knobs can be used to control the
power needed, from minimum to maximum power.
Control off
Maximum
capacity or
aperture and
electricity
on
Minimum
capacity or
aperture
It is normal to hear a slight whistling noise while the
burner is operating.
When it is first used, it is normal for the burner to give off
odours; this does not pose any risk and does not indicate
a malfunction; they will disappear in time.
A few seconds after the burner is switched off, a sound
(thud) will be produced. This is not a fault - this means
that the safety device is no longer operating.
Keep the burner as clean as possible. If the ignition
sparkers are dirty they will not light properly. Clean them
periodically using a small non-wire brush. Bear in mind
that the ignition sparkers must not suffer any serious
impacts.
9