Tabla De Contenido; Important Safety Instructions - Flotec FP6022 Serie Manual Del Usuario

ENGLISH
FP6000 AND FP6100 SERIES
SWIMMING POOL PUMPS
To avoid unneeded service calls, prevent possible injuries, and
get the most out of your pump and filter, READ THIS MANUAL
CAREFULLY!
The Flotec FP6000 series self-priming centrifugal pump is
designed to be used as a filtration or circulation system pump
for in-ground swimming pools, spas, hot tubs, and solar sys-
tems.
The Flotec FP6100 series pump is designed to used as a filtra-
tion or circulation system pump for above ground swimming
pools, spas, hot tubs, and solar systems.
All models:
• Are designed to eliminate corrosion of parts under normal
pool usage and maintenance.
• Are excellent performers; durable, reliable, with non-clogging
impeller.
For other applications of pump, consult manufacturer.
IMPORTANT
SAFETY
INSTRUCTIONS
Always follow basic safety precau-
tions with this equipment, includ-
ing the following.
To reduce the risk of
injury, do not permit children to use
this product unless they are closely
supervised at all times.
This pump is for use
with permanently installed pools and
may also be used with hot tubs and
spas if so marked. Do not use with
storable pools. A permanently
installed pool is constructed in or on
the ground or in a building such that it
cannot be readily disassembled for
storage. A storable pool is construct-
ed so that it may be readily disassem-
bled for storage and reassembled to
its original integrity.
SAVE THESE
INSTRUCTIONS
Safety Instructions......................................................................2
Installation ..................................................................................3
Electrical.....................................................................................4
Operation ...................................................................................5
Troubleshooting Guide...............................................................5
Repair Parts List......................................................................6,7
Warranty.....................................................................................8
Pump has been carefully assembled, tested, inspected and
packed at our factory. Note any damage to product on delivery
ticket and file claim promptly with carrier or store of purchase.
READ AND FOLLOW ALL
INSTRUCTIONS!
This is the safety alert symbol. When you see this symbol on your
system or in this manual, look for one of the following signal words
and be alert to the potential for personal injury.
warns about hazards that will cause death, serious personal
injury, or major property damage if ignored.
warns about hazards that can cause death, serious personal
injury, or major property damage if ignored.
warns about hazards that will or can cause minor personal
injury or property damage if ignored.
NOTICE indicates special instructions not related to hazards.
Carefully read and follow all safety instructions in this manual and on
equipment. Keep safety labels in good condition; replace if missing or dam-
aged.
Incorrectly installed or tested equipment may fail, causing
severe injury or property damage.
Read and follow instructions in owner's manual when installing
and operating equipment. Have a trained pool professional perform all pres-
sure tests.
1. Do not connect system to a high pressure or city water system.
2. Use equipment only in a pool or spa installation.
3. Trapped air in system can cause explosion. BE SURE all air is out of system
before operating or testing equipment.
Before pressure testing, make the following safety checks:
• Check all clamps, bolts, lids, and system accessories before testing.
• Release all air in system before testing.
• Tighten Flotec trap lids to 30 ft. lbs. (4.1 kg-cm) torque for testing.
• Water pressure for test must be less than 25 PSI (172 kPa).
• Water Temperature for test must be less than 100° F. (38° C).
• Limit test to 24 hours. After test, visually check system to be sure it is ready
for operation. Remove trap lid and retighten hand tight only.
NOTICE: These parameters apply to Flotec equipment only. For
non-Flotec equipment, consult manufacturer.
2
TABLE OF CONTENTS
GENERAL