-
The rear of the appliance must be placed against a wall.
Warning! The oven must not be used if:
-
the door is not closed properly;
-
the door hinges are damaged;
-
the contact surfaces between the door and the front of the oven are damaged;
-
the window in the door is damaged;
-
electric arcs occur frequently inside the oven, despite the fact that no metal objects are inside.
The oven may only be used again after it has been duly repaired by a technician from the support
centre.
-
Do not switch the oven on if there is no turntable support, turntable ring or corresponding plate
in place.
-
Never switch the microwave on while it is empty; if there is no food in the oven, an electric
overload may occur, which may damage the oven.
-
Do not cover or obstruct the ventilation openings.
-
Before placing plates and containers in the microwave, make sure they are suitable (refer to the
paragraph on plate types).
-
Do not remove the "mica" sheet on the right-hand side of the oven! This sheet captures
grease and food particles which could damage the microwave generator.
-
Do not place any flammable item inside the oven as, when it is switched on, it may start
burning.
-
Do not use the oven as a larder.
-
Do not use the oven to fry food, because it is impossible to adjust the temperature of the oil
heated in a microwave.
-
To avoid the risk of burns, always wear oven gloves while holding plates and containers and
touching the oven.
-
Do not lean on the open oven door. The oven may be damaged, around the hinged area in
particular.
CLEANING:
-
Warning! Clean the microwave oven regularly.
Remove any food residue (refer to the paragraph on Cleaning the oven). If the microwave oven
is not kept clean, its surface may be damaged and the oven lifespan shortened as a result,
causing a potentially hazardous situation.
-
The door contact surfaces (the front of the cavity and the inside of the door) must be kept
extremely clean in order to guarantee correct oven operation.
-
DO NOT CLEAN THE OVEN DOOR GLASS USING HARD ABRASIVE DETERGENTS OR
SHARP METAL SCRAPERS WHICH COULD DAMAGE THE SURFACE AND CAUSE THE
GLASS TO BREAK.
32