Cleaning And Maintenance; Disposal Of Packaging Materials - Franke Mythos FMY 45 MW XS Información De Instalación Y Seguridad

transport. In the event of problems, contact the
dealer or your nearest After-sales Service. Once
installed, packaging waste (plastic, styrofoam parts
etc.) must be stored out of reach of children - risk of
suffocation. The appliance must be disconnected
from the power supply before any installation
operation - risk of electrical shock.
During installation, make sure the appliance
does not damage the power cable - risk of fire or
electrical shock. Only activate the appliance when
the installation has been completed.
Carry out all cabinet cutting works before fitting
the appliance in the furniture and remove all wood
chips and sawdust.
Do not remove the appliance from its polystyrene
foam base until the time of installation.
After installation, the bottom of the appliance
must no longer be accessible - risk of burn.
Do not install the appliance behind a decorative
door - risk of fire.
If the appliance is installed under the worktop,
do not obstruct the minimum gap between the
worktop and the upper edge of the oven - risk of
burns.
This appliance is intended to be used built-in.
Do not use it freestanding or place into a cabinet.
After unpacking the appliance, make sure that
the appliance door closes properly. In the event of
problems, contact the dealer or your nearest After-
sales Service.
ELECTRICAL WARNINGS
The rating plate is on the front edge of the oven
(visible when the door is open).
It must be possible to disconnect the appliance
from the power supply by unplugging it if plug
is accessible, or by a multi-pole switch installed
upstream of the socket in accordance with the
wiring rules and the appliance must be earthed in
conformity with national electrical safety standards.
Do not use extension leads, multiple sockets or
adapters. The electrical components must not be
accessible to the user after installation. Do not use
the appliance when you are wet or barefoot.
Do not operate this appliance if it has a damaged
power cable or plug, if it is not working properly, or
if it has been damaged or dropped.
If the supply cord is damaged, it must be
replaced with an identical one by the manufacturer,
its service agent or similarly qualified persons in
order to avoid a hazard - risk of electrical shock.
If the power cable needs to be replaced, contact
an authorized service center.
001
6

CLEANING AND MAINTENANCE

WARNING: It is hazardous for anyone other
than a competent person to carry out any service
or repair operation that involves the removal of a
cover which give protection against exposure to
microwave energy.
Failure to maintain the oven in a clean condition
could lead to deterioration of the surface that
could adversely affect the life of the appliance and
possibly result in a hazardous situation.
The oven must be cleaned regularly and any
food deposits removed.
WARNING: Ensure that the appliance is switched
off and disconnected from the power supply before
performing any maintenance operation. To avoid
risk of personal injury use protective gloves (risk of
laceration) and safety shoes (risk of contusion); be
sure to handle by two persons (reduce load); never
use steam cleaning equipment (risk of electric
shock).
Non-professional repairs not authorised by the
manufacturer could result in a risk to health and
safety, for which the manufacturer cannot be held
liable. Any defect or damage caused from non-
professional repairs or maintenance will not be
covered by the guarantee, the terms of which are
outlined in the document delivered with the unit.
Regularly clean appliance door internal side
and related gasket, without removing it. Use a soft
sponge, mild water and neutral soap; dry using a
neutral soft cloth. Do not use metal scrapers.
Do not use harsh abrasive cleaners or metal
scrapers to clean the door glass since they can
scratch the surface, which may result in shattering
of the glass.
Make sure the appliance has cooled down before
cleaning or performing maintenance - risk of burns.

DISPOSAL OF PACKAGING MATERIALS

The packaging material is 100% recyclable and is marked with the
recycle symbol . The various parts of the packaging must therefore
be disposed of responsibly and in full compliance with local authority
regulations governing waste disposal.
DISPOSAL OF HOUSEHOLD APPLIANCES
This appliance is manufactured with recyclable or reusable materials.
Dispose of it in accordance with local waste disposal regulations.
For further information on the treatment, recovery and recycling of
household electrical appliances, contact your local authority, the
collection service for household waste or the store where you purchased
the appliance. This appliance is marked in compliance with European
Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help prevent
negative consequences for the environment and human health.
The symbol on the product or on the accompanying documentation
indicates that it should not be treated as domestic waste but must be
taken to an appropriate collection center for the recycling of electrical
and electronic equipment.