Fitting Battery - Bosch HTD 8 Serie Instrucciones De Uso

5. Unpack the light box and remove the screws. Insert
the light box from above in the sliding block of the
column, taking care to ensure full engagement.
Fig. 7: Inserting the light box in the sliding block
6. Fasten the light box to the sliding block with the
two bolts provided. The bolts must be fitted on the
underside of the light box as shown below.
Fig. 8: Securing the light box
1 Light box
2 Bolt
3 Sliding block
4 Column
7. Unpack the alignment laser, screw it to the mount
and tighten firmly in position. Use the hole in the
alignment laser for this purpose.
Fig. 9: Attaching the alignment laser
8. Remove the locking screw for the counterweight at
the column.
"
This completes device assembly.
Robert Bosch GmbH
Product description | HTD 8xx | 29
3.5.2

Fitting battery

The battery is packed in a separate box.
Fig. 10: Battery: Packed (left) and unpacked (right)
The battery is mounted on a bracket.
Fitting battery in light box
1. Remove the bolt at the battery compartment on the
underside of the light box.
Fig. 11: Removing the bolt
2. Battery connection: Connect the connecting cable
to the supply cable, taking care to ensure correct
polarity.
Fig. 12: Connecting the battery
en
|
1 692 104 611 2014-10-15