Troubleshooting; Replacement Parts And Accessories; On Page - Hach DRB 200 Manual Del Usuario

Measure the temperature of the heating block
Measure the temperature of the heating block to make sure that the
temperature shown on the display is correct.
The temperature shown on the display is the temperature in a closed
sample cell that is filled with a liquid. While the temperature of the
heating block is increasing, the temperature of the heating block, near
the heater, may be greater than the temperature shown on the display.
Tools needed:
• Sample cell (2275800)
• Glycerol (anhydrous), 5 mL
• Thermometer, stem-type, calibrated for 95 to170 °C (203 to 338 °F)
To measure the temperature of the heating block:
1. Fill a clean, empty sample cell with glycerol that is at room
temperature.
2. Put the thermometer in the sample cell until the thermometer touches
the bottom of the sample cell.
3. Make sure that the level of the glycerol is 56 mm ± 0.5 mm (2.20 in. ±
0.02 in.) from the bottom of the sample cell when the thermometer is
in the sample cell.
4. Put the sample cell in the center opening of the second row of the
heating block.
5. Select a temperature program of 150 °C for 60 minutes using the
keys, then push OK.
6. When the heating block is at the selected temperature (two beeps
are heard), the thermometer temperature should be the same as the
temperature shown on the display.

Troubleshooting

Refer to Table 4 for error messages, possible causes and corrective
actions.
10 English
Table 4 Error messages
Error
BLOCK IS TOO HOT! The temperature of the heating block is greater than the
selected temperature. Wait until the temperature of the
PLEASE WAIT
heating block decreases.
INIT ERROR The instrument is defective. Contact Customer Service.

Replacement parts and accessories

W A R N I N G
Personal injury hazard. Use of non-approved parts may cause
personal injury, damage to the instrument or equipment malfunction.
The replacement parts in this section are approved by the
manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the
appropriate distributor or refer to the company website for contact information.
Replacement parts
Description
Protective cover
Accessories
Description
Reducing adapter, 20 > 16 mm
Reducing adapter, 16 > 13 mm
Tube, 16 x 100 mm
Tube, 16 x 100 mm
Thermometer, 0 to 200 °C
Solution
Quantity Item no.
1 LZT048
Quantity Item no.
1 HHA155
1 2895805
1 2275800
6 2275806
1 4565500