Positioning The Booster Seat - Britax SKYLINE Guia Del Usuario

Britax Child Safety, Inc.

Positioning the Booster Seat

Lower anchors can be used to secure the child seat to the vehicle seat even when unoccupied,
since in a crash an unsecured child restraint system may injure occupants� Secure your child using
the vehicle's lap-shoulder belt system�
Lower connectors are not required for proper seat installation� If lower connectors are not used,
ensure they are properly stored in the seat base and do not interfere with the base of the booster
seat�
1� Verify the booster seat is compatible with your vehicle� Refer to
pages 26 - 27 for information about compatible seat belts and
head restraints�
a� Push the booster seat back against the vehicle seat back
and ensure that it is positioned correctly so the vehicle head
restraint allows the backrest to lie flat against the vehicle seat
back�
b� Ensure that the base of the booster seat does not hang over
the edge of the vehicle seat�
2� If the vehicle seat back is adjustable, ensure it is in the upright
position before placing the booster seat on the vehicle seat
(see page 12)�
3� Push the lower connector release button and pull lower
connector to fully extend the lower connector adjuster strap�
Repeat on the opposite side to ensure that all slack has been
released from the lower connector system�
18
4� Attach the lower connectors�
a� Verify the lower anchor adjuster straps are not twisted�
b� Using the lower anchor farthest from you for easiest
positioning push the lower connectors onto their adjacent
lower anchors�
NOTE: You may need to turn the back of the booster seat
towards you for easier access to the lower anchors.
c� A click confirms lower connectors are attached�
IMPORTANT: If a click is not heard when connecting the
lower connectors, the lower anchor adjuster strap may
be twisted or there may be debris in the lower connector�
Correct either situation before continuing with the positioning
process�
5� Guide the booster seat into place while pulling the lower anchor
adjuster strap on either side of the booster seat to remove slack�
NOTE: Only tighten until the slack is removed from the lower
anchor adjuster strap. Over-tightening the strap can force the
backrest of the booster seat forward�
SKYLINE User Guide
19