Positioning The Booster Seat - Britax HIGHPOINTl MIDPOINT Guia Del Usuario

Britax Child Safety, Inc.
Attaching and Removing Lower Connectors from Vehicle Lower Anchors
• To attach, remove the lower connectors from the storage slots
and firmly push down onto the vehicle lower anchors until a
click is heard�
• To remove, push the lower connector release button on the
child's left side of the booster seat to loosen connector strap
(see page 17)� Then press and hold the red lower connector
release buttons and pull the connectors from the vehicle
lower anchors�
16

Positioning the Booster Seat

Use of the lower connectors is not required for proper seat installation� However, the use of lower
connectors, when available, provides additional stability and safety in the event of a crash� If lower
connectors are not used, ensure they are properly stored in the seat base and do not interfere with
the base of the booster seat�
1� Verify the booster seat is compatible with your vehicle� Refer to
pages 24 - 25 for information about compatible seat belts and
head restraints�
a� Push the booster seat back against the vehicle seat back
and ensure that it is positioned correctly so the vehicle head
restraint allows the backrest to lie flat against the vehicle
seat back� Vehicle head restraint may need to be adjusted or
removed (see page 24)�
b� Ensure that the base of the booster seat does not hang over
the edge of the vehicle seat�
2� If the vehicle seat back is adjustable, ensure it is in the upright
position before placing the booster seat on the vehicle seat
(see page 9)�
3� Push the lower connector release button on the child's left side
of the booster seat and pull lower connector to fully extend the
lower connector adjuster strap� Then, repeat on the opposite
side to ensure that all slack has been released from the lower
connector system�
HIGHPOINT/MIDPOINT User Guide
17