Commissioning And Operation - NovoPress ACO202XL Instrucciones De Uso

ACO202XL
8

Commissioning and operation

EN
8.1 Preparing the ACO202XL
CAUTION!
Fingers risk being crushed if the device is operated without a press
jaw/adaptor jaw (Fig. 4)
If no press jaw/adaptor jaw is fitted, fingers could be placed in the at-risk zone.
Fingers could be crushed when the device is started.
Therefore:
– Do not operate the device without the press jaws.
– Keep your fingers away from the at-risk zone.
CAUTION!
Fingers risk being crushed if the device is operated with the finger
guard incorrectly adjusted (Fig. 8)
If the finger guard has not been slid forwards when shorter press jaws are fitted,
fingers could be placed in the at-risk zone. Fingers could be crushed when the device
is started.
Therefore:
– Do not operate the device without having slid the finger guard forwards if shorter
press jaws have been inserted (Fig. 9).
– Keep your fingers away from the at-risk zone.
CAUTION!
Not locking the retaining pin (3) fully can cause damage to the device.
(Fig. 5 to 7)
If the retaining pin is not fully inserted and locked, the cylinder can break during the
pressing operation.
Therefore:
– Press in retaining pin as far as it will go and turn 180° to the rear.
Information!
The press device is not suitable for continuous operation. Following 30
minutes of continuous operation, a short break of at least 15 minutes
must be taken to allow the device to cool down.
• Insert and lock the press jaw/adaptor jaw in the press device as shown in Figs. 5 to 7.
22