Eneo VKCD-1323/IR Instrucciones De Manejo página 24

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• DNR (Digital Noise Reduction)
This function is used to reduce th signal noise on the screen.
• OFF:
There is no reduction in noise level.
• LOW:
There is a small reduction in noise level with almost no ghost image.
• MIDDLE: The most effective mode. There is a sufficient reduction in noise levels without causing much ghost
imaging.
• HIGH:
The level of noise is reduced greatly, however there is an increase in ghost imaging.
NOTE: DNR does not operate if AGC is turned off.
• DSS (Digital Slow Shutter)
This function is used to help maintain a bright, clear screen image by automatically detecting changes in the level
of light condition.
• OFF:
DSS function off
• AUTO:
Low light level auto mode
NOTE: DSS does not operate if SHUTTER is set to FLK or AGC is turned off.
• SPECIAL
CAMERA ID
• ON:
CAMERA ID is displayed in the monitor.
If the CAMERA ID has not been set, please follow these directions:
. Press LEFT or RIGHT key to turn the CAMERA ID mode to „ON".
. Press SET key for the CAMERA ID screen.
3. By pressing RIGHT, LEFT, UP and DOWN keys, select up to 5 letters for your CAMERA ID.
4. Press SET key again to lock those letters.
5. Continue to select letters for the next space.
6. Repeat these steps to input the complete ID.
7. Move the cursor to „POS" and press SET key again.
8. The name will appear on the top left hand corner.
9. Use the LEFT, RIGHT, UP and DOWN keys to select the position of the CAMERA ID.
0. Select „END" and then press SET key to complete ID input.
• OFF:
CAMERA ID is not displayed in the monitor.
COLOR
This function in COLOR mode is used to change the appropriate mode for daytime or night-time.
• COLOR: The COLOR mode is selected electronically.
• AUTO:
The COLOR mode is operated for daytime, and it automatically converts to BW mode for night-time.
• BW:
The BW mode is selected.
BURST MODE
• ON/OFF: Burst signal „ON/OFF" in BW mode
SYNC
This function is used when synchronization with the legacy system is neede.
• INT:
Internal synchronization
4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

92164

Tabla de contenido