Technical Data; Angle Grinder - Hilti AG 230-20D Manual De Uso

Discs
Abrasive cutting disc
Abrasive grinding disc
Suitability of discs for the equipment used
Equipment
Guard
Guard with cover plate
Side handle
Clamping nut
Clamping flange
5

Technical data

5.1

Angle grinder

For details of the rated voltage, frequency, current and input power, refer to the country-specific type
identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the type identification plate of the device. The operating voltage
of the transformer or generator must always be within +5% and -15% of the rated voltage of the device.
Weight in accordance with EPTA procedure 01
Maximum disc diameter
Thread length
Thread diameter
5.2 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: Maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound power level (L
WA
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Surface grinding with the vibration-absorbing side handle (a
Uncertainty (K)
*2121808*
Application
Cutting, slitting
Rough grinding
)
)
pA
)
pA
2121808
Designation
AC­D
AG-D
AC­D AG-D AF-D
— X X
X — —
X X X
X X X
X X X
5.3 kg
230 mm
15 mm
M14
105 dB(A)
94 dB(A)
3 dB(A)
) 6.2 m/s²
h,AG
1.5 m/s²
Material
Metal
metal
AN-D
X
—
X
X
X
English 19