Symbols Used - Linde Safety Guard Manual Del Usuario

1
Introduction

Symbols used

HR IT CY
PL PT RO
This LT2 system (Location Tracking System
Type 2), which works in the range from 3.1
GHz to 4.8 GHz (see ECC/REC (11) 09 [i.8]),
is intended for tracking people and objects in
industrial applications at clearly defined loca-
tions. The sending terminals in this system
may be located inside or outside and can be
Symbols used
The terms DANGER, WARNING, CAUTION,
NOTE and ENVIRONMENT NOTE are used
in these operating instructions for notes on
particular hazards or for unusual information
that needs to be highlighted:
DANGER
Means that failure to comply can cause risk to life
and/or major damage to property.
WARNING
Means that failure to comply can cause risk of seri-
ous injury and/or major damage to property.
CAUTION
Means that failure to comply can cause risk of mate-
rial damage or destruction.
4
LV LT LU
SI SK FI
HU MT
SE UK
permanently installed or mobile. The system
operates at fixed locations and may require
approval that requires coordination with possi-
ble interference devices with regard to possi-
ble malfunctions, ECC report 167 [i.10] and
ECC report 170 [i.11].
NOTE
Means that particular attention is drawn to
combinations of technical factors which may
not be evident even to a specialist.
ENVIRONMENT NOTE
The instructions listed here must be complied
with as otherwise environmental damage may
result.
CAUTION
This label is found on the truck in the
areas where particular care and atten-
tion are required.
You should refer to the appropriate sec-
tion in these operating instructions.
For your safety, additional symbols are also
used. Please heed the various symbols.
Operating Instructions - 3008011701 EN - 11/2019
NL AT