Environmental Protection; Circuit Diagram; Standard Spare Parts; Minimising Wear And Preventing Damage - Viking GE 150 Manual De Instrucciones

12.2 Lifting or carrying the
garden shredder
At least two persons are always
required to lift and carry the
machine.
Wear suitable protective clothing;
the lower arms and upper part of
the body must be fully covered.
● 1. First person: Hold the garden
shredder at the handles on the upper
chute (1).
● 2. Second person: Hold the garden
shredder at the bar of the ejection chute
extension (2).
● Lift the garden shredder
simultaneously.
12.3 Transporting the garden
shredder on a load floor
● Secure the machine against
slipping using suitable fastening
materials. Attach ropes or straps to the
wheel carrier (1) or the feed chute (2).

13. Environmental protection

Shredding material should be
composted and not disposed of
in household waste.
The machine, its packaging and
accessories are all produced
from recyclable materials and must be
disposed of accordingly.
0478 201 9906 D - EN
By disposing of materials separately, and
in an environmentally friendly manner,
valuable resources can be re-used. For
21
this reason, the machine should be
disposed of for recycling at the end of its
useful life.

14. Circuit diagram

Item Designation
1 Mains plug
2 Switch
3 Safety switch
4 Electric motor
5 Capacitor
BR brown
BK black
BL blue
YG yellow/green
22

15. Standard spare parts

Reversible blade:
6008 702 0121
Wing blade:
6008 702 0300
GE 150, GE 250 S, GE 260 S
Blade disc assembly:
6008 700 5120
GE 250, GE 260
Blade disc assembly:
6008 700 5117
Wing blade:
6008 702 0310
Shredding blade:
6008 702 0110
16. Minimising wear and
preventing damage
Important information on maintenance
and care of the product group
Electric garden shredders
VIKING assumes no liability for material or
personal damage caused by the non-
observance of information contained in the
operating instructions, in particular with
23
regard to safety, operation and
maintenance, or which arise through the
use of unauthorised attachment or spare
parts.
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Blade
– Blade disc
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Inadequately dimensioned power
cables (cross section)
45