Briggs & Stratton XL4000 Manual Del Operario página 13

SPECIFICATIONS
Starting Wattage ..................... 5,300 _Vatts
VVattage ............................. 4,000 _/atts
Rated AC Load Current
At 120Volts ....................... 33.3 Amps
At 240 Volts ....................... 16.6 Amps
Phase .................................. I-phase
Rated Frequency
.......................
60 Hertz
Fuel Tan[< Capacity .................. 4.5 U.S. gallons
Shipping_^¢eight .......................... 151 [bs.
GENERAL MAINTENANCE
RECOMMENDATIONS
The Owner/Operator is responsible for making sure that
all periodic maintenance tasks are completed on a timely
basis; that all discrepancies are corrected; and that the unit
is kept clean and properly stored. NEVER operate a
damaged or defective generator.
NOTE: Should you have questions about rep[adng
components on your Briggs & Stratton Power Products
generator, please call [°800°743°4 [ [ 5 for assistance.
Engine Maintenance
See engine operator's manual for instructions.
CAUTION
, Used motor oil has been shown to cause skin cancer in
certain [aborator 7 animals.
, Thorough[ 7 wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
NOTE: DO NOT use a garden hose to clean generator.
_¢ater can enter engine fuel system and cause problems. In
addition, if water enters generator through cooling air slots,
some of the water will be retained in voids and cracks of
the rotor and stator winding insulation.Water and dirt
buildup on the generator internal windings will eventually
decrease the insulation resistance of these windings.
WANNING
WHEN ADJUSTING OR MAKING REPAIRSTOYOUR
GENERATOR
Disconnect the spar[< plug wire from the spark plug and place
the wire where it cannot contact spark plug.
WNENTESTING FOR ENGINE SPARK
Use approved spar[< plug tester.
DO NOT check for spar[< with spar[< plug removed.
Generator Cleaning
Use a damp cloth to wipe exterior surfaces clean.
®
®
®
DO NOT expose generator to excessive moisture, dust, dirt,
or corrosive vapors.
DO NOT insert any obiects through cooling slots.
Use a soft bristle brush to loosen caked on dirt or oil.
Use a vacuum cleaner to pick up loose dirt and debris.
Use low pressure air (not to exceed 25 psi) to blow
away dirt. Inspect cooling air slots and opening on
generator.These openings must be kept clean and
unobstructed.
Generator Maintenance
Generator maintenance consists
of keeping the unit clean
and dry. Operate and store the unit in a clean dry
environment where it will not be exposed to excessive
dust, dirt, moisture or any corrosive vapors. Cooling air
slots in the generator must not become dogged with snow,
[eaves or any other foreign material