Briggs & Stratton XL4000 Manual Del Operario página 15

TROUBLESHOOTING
Problem
No AC output is available, but
generator is running°
Generator runs good at no°load
but "bogs" down" when loads are
connected,
Generator will not start; or starts
and runs rough,
Generator shuts down during
operation,
Generator
[acks power.
Cause
I. One of the circuit breakers is open.
2. Fault in generator.
3. Poor connection or defective cord
set.
4. Connected device is bad.
I. Short circuit in a connected load.
2. Generator
is overloaded.
3. Shorted generator circuit.
Low oil level.
I.
Out of gasoline.
2.
Low oil level.
Load is too high.
I. Reset circuit breaker.
2. Contact Authorized service facility.
3. Check and repair.
4. Connect another
device that is in
good condition.
I. Disconnect shorted electrical load.
2. See "Don't Overload Generator".
3. Contact Authorized service facility.
Fill crankcase to proper level or place
generator on level surface.
I. Fill fuel tank.
2. Fill crankcase to proper level or
place generator on level surface.
See "Don't Overload Generator".