TecniDelta MAYOR 1720 2G Manual De Usuario página 60

EN
5.2 HYDRAULIC CONNECTIONS
Before setting up the machine, it is advisable to check the effi ciency of the
water network (point 10, picture 5.1).
It is necessary to verify the effi ciency of the sewage pipe (with siphon) and
connect it with the machine's discharge tube (point 7, picture 5.1).
Hydraulic connections:
„ Water entrance: 3/8 union, pipe int diam 10/12 mm
„ Discharge: Pipe int diam 16/17mm
Install the machine as referred in chapter 5.1. Connect the water purifi er (must
stay in vertical position), (see point 12, picture 5.1).
Connect the purifi er with the passage valve trough tube "11" (point 9, picture
5.1).
Ligue o depurador com a torneira de passagem (detalhe 9, Fig 5.1) mediante o
tubo "11".
Connect tube "13" with the purifi ed water entrance (point 5, picture 5.1). Con-
nect tube "7" with the discharge tray (point 6, picture 5.1) and then with the
sewage pipe "8".
Place a container under the purifi er's drain pipe (see "Instructions to regene-
rate the purifi er").
Open the passage valve (point 9, picture 5.1) and let water fl ow for a few mi-
nutes to clean the purifi er).
Water network pressure must stabilize between 2 and 4 bar, otherwise use a
pressure reducer. pressure reducer.
fi gura 5.2
60