Feet; Joining The Frames; Seat Back - Tunturi E4R Manual Del Usuario

FEET

Secure the rear foot with two M10 bolts (D)
1.
and washers (E) to the lower frame. At this point
tighten the bolts only with your fingers.
Lift the cycle on the floor and turn it right side
2.
up.
Fasten the front foot with the transportation
3.
wheels to the front frame the same way.

JOINING THE FRAMES

Remove the M5 screws in the front and seat
1.
frames.
Connect the handgrip pulse wires with the
2.
connectors in the front frame.
Join the front frame and seat frame by pushing
3.
one tube inside the other so that the screw holes
in the tubes match together.
Fasten the frames with two M8 screws (F) and
4.
washers (C). Do not damage the hand grip pulse
wires.
O W N E R ' S M A N U A L
Secure the drink bottle rack in place with the
5.
M5 screws.
Tighten the rear and front foot screws.
6.
Push the plastic caps over the nuts.
7.

SEAT BACK

Push the fastening screw (G) through the hole
1.
in the seat frame tube and the assembly plate.
Place the bushing (H) on the fastening screw
2.
and secure the plate by tightening the nut (I) on
the fastening screw.
Remove the fastening nuts and washers of
3.
the seat back and attach the seat back to the
assembly plate with them.
Push the plastic caps over the nuts.
4.
GB
•
E 4 R
5