Tunturi F20 Manual Del Usuario página 4

SEAT
Unscrew the seat support's locking knob
1.
counterclockwise and pull the knob out.
Push the seat support in place and tighten with
2 .
the locking knob clockwise.
Attach the seat to the seat support: tighten the
3 .
locking nuts in opposite directions. Please note
that you can adjust both seat inclination and the
distance of the seat from the handlebar. Once the
distance and inclination are set how you want,
tighten the locking nuts carefully.
HANDLEBAR SUPPORT TUBE
Remove the 6 washers and screws from the
1.
frame tube.
Adjust the resistance knob to position 1. Attach
2 .
4
the break wire from the handlebar support tube to
the break wire connector in the frame tube.
Attach the wires from the frame tube and
3 .
the handlebar support tube. Push the handlebar
support tube into place inside the frame tube.
Secure the handlebar support tube with 6
4 .
washers and screws.
HANDLEBAR
Thread the wire from the handlebar through the
1.
hole in the handlebar tube and out through the top
of the tube.
Install the handlebar.
2 . I M P O R TA N T !
handlebar pin must be aligned with the groove in
the socket!
Place the socket's mating piece over the
3 .
handlebar attachment point and tighten with a
fastening screw and two washers through the upper
screw hole.
I M P O R TA N T !
fastening screw: you should be able to adjust the
position of the handlebar.
Place the plastic cover over the handlebar
4 .
attachment point.
Place two washers and a bushing over the
5.
handlebar fastening screw and tighten fastening
screw through the lower hole in the plastic cover.
Be careful not to damage the wire!
The
Do not overtighten the