SATA air vision 5000 Instrucciones De Servicio página 84

Operating instructions SATA air vision 5000
EN
Use the adjusting screw [4-4] to make the head fixation larger or smaller
until it fits the head neatly without any pressure.
Adjust height of the head straps
The lower edge of the front comfort band [4-5] should be approx. 1 cm
above the eyebrows. To this end, make the head band [4-2] longer or
shorter by slotting it in at the right position. The enclosed comfort band
can be fitted to the head band for a pleasant cushioning effect.
Insert head straps in the hood shell
Notice!
The front fixing tabs on the hood shell can be slotted into 2 positions
(Pos. 1, Pos. 2) for different head sizes. There are two different slotted
positions. The rear fixing tabs have two rows (Pos. 1, Pos. 2) for ad-
justing the slant of the breathing protection hood.
■ Fit the front fixing tabs [4-1] in Pos. 1 or Pos. 2 and slot in completely.
■ Fasten the rear fixing tabs [4-3] in Pos. 1 or Pos. 2 at the hood shell
pin.
8.3. Check seating position of the breathing protection hood
Notice!
The hygiene insert must cover the whole face contour, and the field of
vision through the visor may not be restricted (beards etc.). Otherwise,
correct the front or rear fixing tabs [4-1], [4-3], the head band [4-2] or
the adjusting screw [4-4].
■ Put on the breathing protection hood with open visor.
■ Check the settings of the head straps and correct them if necessary.
■ Close the visor.
8.4. Attach hood cloth
Notice!
The fabric properties of the hood cover comply with DIN EN 14116
Index 1 (heat and flame protection) and DIN EN 1149-3 (electrostat-
ic properties). Protective material properties can change after being
washed 5 times (dry cleaning).
■ Align the hood cover [2-15] with the centre marking [2-20] to the upper
middle visor bolt.
84