Normal Operation - SATA air vision 5000 Instrucciones De Servicio

■ Fasten the hook-and-loop tape [2-21] to the visor.
■ Insert the hood cloth in the groove at the transition to the visor.
■ Fasten the hook-and-loop tapes [2-16] to the breathing protection hood.
■ Take the air hose through the air hose loop [2-17] .

9. Normal Operation

Before any use, check the following points to ensure safe work with the
breathing protection hood.
■ Adhere to all safety and hazard warnings in this operating manual.
■ Air supply operating pressure.
■ Fasten hood cloth properly.
■ Ensure the hood cloth is undamaged and clean.
■ Ensure the vision through the visor is unimpaired.
■ Only use intact SATA safety compressed air tubes.
■ Breathing protection hood is properly seated.
■ Aluminium is present at the front comfort head band and clean.
■ Visor fixed and fully functional.
9.1. Put on the breathing protection hood.
Notice!
For people who wear spectacles, these may get displaced by the hy-
giene insert [2-12]. If necessary, open the visor foil [2-10] on one side,
adjust your spectacles and then fasten the visor foil properly again.
■ Put on the breathing protection hood with open visor.
■ Check the setting of the head fixation. Fix the breathing protection hood
with the adjusting screw [4-4].
■ Close the visor.
■ Check the seating and impermeability of the facial seal as well as the
field of vision.
■ Close the hood cover at the chest with the hook-and-loop tapes [2-18],
[2-19].
Operating instructions SATA air vision 5000
EN
85