Krups 889 Instrucciones De Uso página 25

Problems, possible causes and remedies
Problems
Espresso or coffee is not
hot enough
Only a small amount of
espresso or coffee runs out
Too little froth produced
when frothing up
The mill makes a very loud
noise
Drawer with attachment
and spent coffee holder
cannot be re-inserted
The cleaning programme
refuses to start
Cause
The cups are too cold
Too little coffee-meal has
been used
The coffee-bean
container is empty
Unsuitable milk, either
too old, wrong fat
content or too warm
Steam nozzle is blocked
Air suction hole in the
frothing aid is blocked
Some foreign body in the
grinder
Electricity supply failure
or the mains plug not
inserted
Steam has just been
produced
Remedies
Pre-warm the cups with
hot water
Use the correct quantity
of coffee-meal
Add further coffee-beans
Use different milk
Clean the steam nozzle
Clean the frothing aid
Let the KRUPS service
unit examine the
appliance
Continue using the
appliance, but only with
pre-ground coffee
Insert mains plug and
insert only the drawer
and attachment.
Then switch on the
appliance and insert the
spent coffee holder.
Fill the heating system
25