Delta 28-206 Manual De Instrucciones página 13

Sierra de cinta de 14 pulg.
Ocultar thumbs Ver también para 28-206:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

14. Align the four holes in the short brace (A) Fig. 14 with the four holes in the two legs (B).
15. Insert a carriage head bolt (M8x1.25x16mm) through the hole in the stand and the hole the short brace.
16. Thread a flange nut (M8x1.25) on the screw.
NOTE: Loosely tighten the hardware for further adjustment.
17. Repeat this process for the three remaining holes.
18. Attach the remaining short brace to the opposite side of the stand in the same manner.
19. Align the four holes in the long brace (A) Fig. 15 with the four holes in the two legs (B).
20. Insert a carriage head bolt (M8x1.25x16mm) through the hole in the stand and the hole in the long brace.
21. Thread a flange nut (M8x1.25) on the screw.
NOTE: Loosely tighten the hardware for further adjustment.
22. Repeat this process for the three remaining holes.
23. Attach the remaining long brace to the opposite side of the stand in the same manner.
Fig. 14
24. Turn the stand right side up.
25. Thread a hex nut (M10x1.5) on a hex head screw (M10x1.5x80mm) approximately 1/4".
26. Thread the hex head screw into the hole (A) Fig. 16 in the top of the stand. Place the damping cap (A) Fig. 16A on
the threaded end of the screw (C).
27. Confirm that the stand is level.
28. Securely tighten all hardware.
NOTE: Pulley guards (D) and (C) will be attached after the belt has been installed.
A
Fig. 16
A
B
D
B
C
Fig. 15
C
Fig. 16A
13 - English
B
A
A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

28-276

Tabla de contenido