Standard Measurement Display; Graphical Measurement Display - Hach ORBISPHERE 3100 Manual Básico Del Usuario

Note: These user lists are defined by the user on the PC (see
the instrument (see Transfer files to the instrument
Press the up and down arrow keys to scroll through the list of users. When the required one is
highlighted press the Enter key to select it. If a supervisor level user is selected a password will be
required (by default Supervisor1 is 5678). On completion, the display returns to the measurement
screen.

5.4 Standard measurement display

1 Instrument date and time
2 Measurement location and product name
3 User name
4 Sample temperature
5 Measured gas
6 Measurement unit
• The user name will be displayed in green for a standard user, or blue for a supervisor
• The battery life remaining will not be displayed if using mains power supply, instead the icon will
show the battery recharging symbol
• The measurement value is normally displayed in blue, but will be displayed in red if it is outside the
high or low value alarm limits
• If measurement is in sample mode, the bottle icon is displayed at the top right of the screen. If
measurement mode is set to continuous, the bottle icon will be displayed with a cross through it
• The measurement display is refreshed every 5 seconds

5.5 Graphical measurement display

To access this display from the standard measurement display screen, press the right arrow key on
the keypad until the graphic screen is displayed:
This screen gives a graphical representation of the measurement with the numeric value of the
measurement displayed at the end of the curve. The above example shows the measurement in
sample mode.
The numeric measurement value at the end of the curve is refreshed every 5 seconds. The curve is
refreshed every 5 seconds in sample mode. In continuous mode, the refreshment rate is the same as
that defined as the storage interval parameter.
The graphic timescale is displayed at the bottom of the screen. This value can be increased or
decreased (4 zoom levels) by pressing the up and down arrows on the keyboard. These values are
Create new user table
on page 10).
7 Battery life remaining
8 USB symbol indicates USB key attached
9 Measurement mode (continuous shown)
10 High level alarm value (if set)
11 Low level alarm value (if set)
12 Measurement value
on page 10) and imported into
English 13