Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.1 Installation startup checklist
1. Reconnect the battery pack in order to supply power to the instrument as described in
battery power
on page 7.
2. Switch the machine ON using the ON/OFF switch (No. 2 in
batteries need charging, connect the instrument to an external power source as described in
External power
on page 9.
3. Next, familiarize yourself with using the instrument by reading the next section in this manual
entitled
User interface
4. Set the date and time of the instrument's internal clock, as described in
on page 15.
5. Install the 3100 PC software on your PC as described in
6. Set up the user configuration table using the PC software as described in
on page 10.
7. Set up the measurement configuration table using the PC software as described in
measurement configuration table
8. Upload the user and measurement configuration tables to the instrument as described in
files to the instrument
4.2 Reconnect battery power
For safety reasons, the battery pack will not be connected during shipment. Once the instrument has
been unpacked, the battery power should be reconnected using the following procedure:
1. Tilt the instrument towards the rear, to reveal two screws underneath (No. 1) that hold the
instrument front panel in place.
2. Using the cross screwdriver supplied in the tool kit, unscrew and remove these screws. Lift off the
front panel to reveal the internal battery power switch (No. 2).
3. Using the long-bladed flat-head screwdriver supplied in the tool kit, turn the switch a quarter of a
turn clockwise to reconnect the battery power. The diagrams below show the switch in the OFF
position as delivered (left) and in the ON position (right).
4. Replace the front panel and secure back in place with the two screws.
To avoid any damage to the instrument, it will be necessary to perform the above procedure in reverse (i.e.
turn the connection OFF) prior to any future transportation of this instrument.
on page 11.
on page 10.
on page 10.
C A U T I O N
Figure 1
on page 8). If the
Basic settings
PC software installation
Create new user table
Reconnect
on page 10.
Create new
Transfer
English 7
Publicidad
Tabla de contenido
