Hach ORBISPHERE 3100 Manual Básico Del Usuario página 3

Table of Contents
1 Specifications on page 3
2 Expanded manual version
3 General information
4 Installation on page 6
5 User interface on page 11
Section 1 Specifications
Specifications are subject to change without notice
Specification
Sample
Measurement range
Accuracy
Repeatability r95
Detection limits
Response time t90
Measurements
Display units
Operating conditions
Weight
Dimensions (L x W x H)
Maximum altitude
Waterproof protection
Power supply
Battery life
Battery charge time
EMC requirements
on page 4
on page 4
Details
Non-flammable gaseous or liquid samples
Sample temperature
Sample pressure
0 to 2000 ppb
± 0.8 ppb or ± 2% of reading whichever is the greater
± 0.4 ppb or ± 1% of reading whichever is the greater
0.6 ppb
Usually less than 15 seconds but will vary depending on the sampling method
Holds up to
5,760 measurements
O concentration
2
Pressure
Temperature
Ambient temperature
Relative humidity
3.4 kg (7.5 lbs)
200 x 170 x 190 mm (7.87 x 6.69 x 7.48 ins)
2000 m (6562 ft) maximum
Stainless steel IP66 with polycarbonate sides
Internal rechargeable battery pack: Li-Ion 46Wh
External power supply input: 100-240 VAC ±10% @ 47-63 Hz
External power supply output: 12 VDC, 3.75 A
Note: External power supply is not IP66
> 10 hours of continuous measurement
< 4 hours
Note: Charge time increases by 20% at a temperature above 35°C (95°F)
EN61326-1: EMC Directive
6 Main menu on page 14
7 Maintenance on page 21
8 Troubleshooting on page 22
9 Instrument storage when not used
-5 to 45°C (23 to 113°F)
0 to 10 bar (0 to 140 psi)
8 hours of data at a sampling frequency of 5 seconds
96 hours of data at a sampling frequency of 1 minute
ppb, ppm, μg/L, mg/L, mL/L, %O
mbar, bar, Pa, hPa, kPa, MPa, psia, psig, atm, kgf/cm2
°C, °F, K
-5 to 45°C (23 to 113°F)
0 to 95% non-condensing for temperatures less than
30°C (86°F)
0 to 70% non-condensing for temperatures from 30 to
45°C (86 to 113°F)
on page 23
, %air, %Vbar, ppmVbar
2
English 3