Hitachi CD 14F Manual De Instrucciones página 5

6.
Always confirm that all components are mounted properly and securely before using the tool.
7.
When replacing the saw blade, always confirm that the rpm rating of the new blade is correct for use
on this tool.
8.
Always shut off the power and wait for the saw blade to completely stop rotating before doing any
maintenance or adjustments.
9.
Always clamp or otherwise secure the workpiece to the vise; otherwise the workpiece might be thrown
from the base and cause bodily harm.
10.
Always confirm that the saw blade is free from any cracks, before using the tool.
11.
Always confirm that the parts which fix the saw blade are not damaged.
Damaged parts cause the breakage of the saw blade.
12.
During bevel cutting, always wait for the rotation of the blade to stop completely before lifting the saw
blade.
13.
Always make a trial run first before attempting any new use of the saw.
14.
Always use only the peripheral surface of the saw blade.
15.
Always handle the saw blade with care, when dismounting and mounting it.
16.
Always keep your hands out of the line of the saw blade.
17.
Always confirm that the safety cover are in the proper places, before using the tool.
18.
Inspect the tool power cord periodically.
19.
Always confirm that the proper lengths and types of extension cords are being utilized, if necessary,
before starting the tool.
20.
Always confirm that the motor air vents are fully open before using the tool.
21.
Always wait until the motor has reached full speed before starting a cut.
22.
Always keep the handles dry, clean and free of oil and grease. Hold the tool firmly when in use.
23.
Always operate the tool after ensuring the workpiece is fixed properly with a vise assembly.
24.
Always fix the motor section using the chain when carrying about the tool.
25.
Always use only wheel washer specified for this tool.
26.
Always confirm that blade does not contact the base in the lower limit position before operating.
27.
Always be alert at all times, especially during repetitive, monotonous operations. Don't be lulled into a
false sense of security. Blades are extremely unforgiving.
28.
Always hold the handle firmly. Be aware that the saw moves up or down slightly during start-up and
stopping.
29.
Always confirm the blade is not contacting the workpiece before switch is turned on.
30.
Always confirm before using the tool on an actual workpiece, let it run for a while. Watch for vibration
or wobbing that could indicate poor installation or a poorly balanced blade.
31.
Always turn off tool and wait for saw blade to stop before moving workpiece or changing settings.
32.
If you are not thoroughly familiar with the operation of dry cut metal cutting machine, obtain advice
from your supervisor, instructor or other qualified person.
33.
Always tighten arbor screw and all clamps before operating.
34.
Always provide adequate support to the sides of the saw table for long workpiece.
35.
Always confirm the inside surfaces of the blade flanges as well as the sides of the blade are free from
any foreign matter.
36.
After turning machine on, gently lower the blade to engage workpiece, then slowly increase pressure
as required to produce the least amount of sparking.
37.
Should any part of your machine be missing, damaged or fail in any way, or any electrical component
fail to perform properly, shut-off switch and remove plug from power supply outlet. Replace missing,
damaged or failed parts before resuming violently.
English
5