Hitachi CD 14F Manual De Instrucciones página 6

Tronzadora
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
DON'Ts
NEVER VIOLATE THE FOLLOWING RULES TO ASSURE SAFE USE OF THIS TOOL:
1.
Never operate the POWER TOOL unless you fully understand the operating instructions contained in
this Manual.
2.
Never leave the POWER TOOL unattended without first unplugging the power cord.
3.
Never operate the POWER TOOL when you are tired, after you have taken any medications, or have
consumed any alcoholic beverages.
4.
Never use the POWER TOOL for applications not specified in the instruction manual.
5.
Never operate the tool while wearing loose clothing, a necktie or jewelry, or while your hair is uncovered,
to protect against getting caught in the moving machinery.
6.
Never reach around or behind the saw blade.
7.
Never touch any moving parts, including the saw blade, while the tool is in use.
8.
Never remove any safety devices or blade guards; use of the tool without them would be hazardous.
9.
Never lock the safety cover; always confirm that it slides smoothly before using the tool.
10.
Never damage the power cord of the tool.
11.
Never attempt to move a plugged-in POWER TOOL while your finger is on the starting switch.
12.
Never use the POWER TOOL if the starting switch does not turn on and off properly.
13.
Never use the POWER TOOL if the plastic housing or the handle is cracked or deformed.
14.
Never use the POWER TOOL near flammable liquids or gases because sparking can cause an explo-
sion.
15.
Never clean plastic components with solvents because the plastic may dissolve.
16.
Never operate the tool unless all of the blade cover are in place.
17.
Never raise the saw blade from the workpiece until it has first come to a complete stop.
18.
Never allow the saw blade to be struck against a hard object, as it might get cracked.
19.
Never twist the saw blade during cutting operation.
20.
Never expose hands, feet and fragile things to the grinding sparks, as the grinding sparks may harm
them.
21.
Never use the lateral side of the saw blade.
22.
Never place your limbs inside of the while the tool is being operated. This may cause hazardous
conditions.
23.
Never use abrasive type blades on this saw.
24.
Never expose to rain or use in damp locations.
25.
Never confirm the piece being cut off. Never hold it, clamp it, touch it, or use length stops against it
while the blade is turning. It must be free to move side ways, if confired, it could wedge against the
blade and be thrown violently.
WARNING
FOR YOUR OWN SAFETY READ THIS INSTRUCTION MANUAL BEFORE OPERATING THE
DRY CUT METAL SAW
1.
Always wear eye protection when using the dry cut metal saw.
2.
Always keep hands out of the path of the saw blade.
3.
Never operate the dry cut metal saw without the guards in place.
4.
Never perform any freehand operation with the dry cut metal saw.
5.
Never reach around the saw blade.
6.
Always shut off the power and wait for the saw blade to stop turning before adjusting or maintaining
the tool.
7.
Saw blade diameter is 14" (355mm).
8.
No load speed is 1490rpm.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido