Mounting On A Commercially Available Board; Attaching The Remote Controller; How To Use The Wire Clamp - JVC CS-DA1 Manual De Instrucciones

Mounting on a commercially available board

After step 1, use screws to secure the unit on the commercially available board. In this case, the
mounting bracket C need not be used.
Horizontal installation
Board (Commercially available
item: Thickness 23/32 inch / 18 mm and above)

Attaching the remote controller

Do not place the remote controller where it will
be exposed to direct sunlight.
Double-sided tape
Peel off the sheet
NOTE:
• Clean the item thoroughly before attaching.
8
Tapping screw
(Dia. 3/16 inch c 13/16 inch
/ M 4 mm c 20 mm) c 4
Vertical installation
Tapping screw
/ M 4 mm c 20 mm) c 4
Board (Commercially available
item: Thickness 23/32 inch / 18 mm and above)

How to use the wire clamp

To prevent the remote control cord or the L-
shaped pin plug relay cord from falling off due
to vibration, secure all cords with the attached
wire clamp after all connection is completed.
Power cord
Pull
Wire clamp
Remote controller cord
leave a little longer
(Dia. 3/16 inch c 13/16 inch
Allow the L-shaped
pin plug relay to sag
slightly