Connections - JVC CS-DA1 Manual De Instrucciones

CONNECTIONS

When using speaker input terminal
Set the LPF switch to either
A110 HzB or A85 HzB according
to your preference.
1 : TO L CHANNEL SPEAKER OUTPUT
2 : TO R CHANNEL SPEAKER OUTPUT
NOTES:
• The volume of this unit is set to the maximum when the remote controller is not connected.
• If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the front
speaker output of the receiver.
When no remote output is equipped for
your car receiver, connect to the ACC
power.
CS-DA1
Power cord
Blue/White
Remote input TO
REMOTE
OUT
Speaker input
TO
cord
SPEAKER
INPUT
Speaker
input
Connect to stereo output
with maximum power 60 W
or lower (per channel).
POWER LEAD
GROUND
ACC power cord
Crimp connector
Remote output
Left speaker
White/Black White
White
1
Gray
2
Gray Gray/Black
Right speaker
Fuse
Yellow
15A
Black
Remote controller
Left speaker
JVC Car
receiver, etc.
Right speaker
Connect only to the plus +
side of the battery.
Connect to the metal part
(such as the chassis) of the
car.
9