JVC CS-DA1 Manual De Instrucciones página 14

When using LINE IN terminal
[Connecting to line output]
Set the LPF switch to either
A110 HzB or A85 HzB according
to your preference.
L-shaped
pin plug
relay cord
NOTES:
• The volume of this unit is set to the maximum when the remote controller is not connected.
• If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the front
speaker output of the receiver.
10
When no remote output is equipped for
your car receiver, connect to the ACC
power.
CS-DA1
Power cord
Blue/White
Remote input
TO
REMOTE
OUT
TO
SPEAKER
INPUT
This is not used when LINE IN
terminal is used.
Speaker
input
POWER LEAD
GROUND
ACC power cord
Crimp connector
Remote output
Pin cord (not supplied)
Fuse
15A
Black
Remote controller
JVC Car
receiver, etc.
Line output
Yellow
Connect only to the plus +
side of the battery.
Connect to the metal part
(such as the chassis) of the
car.