Maintenance And Care; Troubleshooting - Schumacher DSR118 Manual Del Usuario

BATTERY DISCONNECTED – The charger's connection to the battery has been lost.
FULLY CHARGED - AUTO MAINTAINING (green Charged/Maintaining LED solid) –
Plugged into the AC outlet and correctly connected to a fully charged 6 or 12V battery.
BOOST ON (yellow/orange Charging LED lit) – The charger is in Boost mode.
SERVICE ON (yellow/orange Charging LED lit) – The charger is in Service mode.
ENGINE START ON – Shows during the first 2 minutes of Engine Start mode.
READY – Shows after 2 minutes in Engine Start mode. The charger is ready for Engine Start.
COOL DOWN xxx SECONDS REMAINING – The charger is in a mandatory 3 minute (180 second)
cool down state.

13. MAINTENANCE AND CARE

A minimal amount of care can keep your battery charger working properly for years.
• Clean the clamps each time you are finished charging. Wipe off any battery fluid that may have come in
contact with the clamps to prevent corrosion.
• Occasionally cleaning the case of the charger with a soft cloth will keep the finish shiny and help
prevent corrosion.
• Coil the input and output cords neatly when storing the charger. This will help prevent accidental damage
to the cords and charger.
• Store the charger unplugged from the AC power outlet in an upright position.
• Store inside, in a cool, dry place. Do not store the clamps on the handle, clipped together, on or around
metal, or clipped to the cables.

14. TROUBLESHOOTING

PROBLEM
The charger will not turn on
when properly connected.
Battery clamps do not spark
when touched together.
The battery is connected and
the charger is on, but is not
charging.
No reading on the digital
display.
Yellow/orange Charging LED
is solid and the display shows
ANALYZING BATTERY.
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical connection.
Battery is defective.
The charger is equipped with an
auto-start feature. It will not supply
current to the battery clamps until
a battery is properly connected.
The clamps will not spark if
touched together.
The charger is in tester mode, not
charge mode.
Charger is not plugged in.
No power at the receptacle.
The display is in sleep mode,
during charging.
The charger needs to check the
condition of the battery.
• 12 •
SOLUTION
Check for open fuse or circuit breaker
supplying AC outlet.
Check power cord and extension cord
for loose fitting plug.
Have battery checked.
No problem; this is a normal
condition.
Press the Mode Selection button to
activate a mode.
Plug the charger into an AC outlet.
Check for open fuse or circuit breaker
supplying AC outlet.
Press the Display button to turn the
display back on.
The charger has not completed the
checking process. This process can
last for up to 5 minutes, if the starting
voltage is below 8.0V.