Kvm S4 Switch Sessions - Fujitsu Control 4 Serie Guia Del Usuario

an exclamation point and the name of the failure will appear in the header of
each screen. This notification will appear or disappear only after you refresh the
page. You can click on the notification to get more information.
3.3 KVM s4 Switch Sessions
From the Active Sessions screen, you can view a list of active sessions and the
following information about each session: Target Device, Owner, Remote Host,
Duration, and Type.
Launching a session
Java 1.6.0_11 or later is required to launch a session.
To launch a session:
1. From the side navigation bar, select Unit View > Target Devices. A list of
available devices will appear.
2. Click the KVM Session or Serial Session link to the right of the desired target
device to launch the session.
If the target device is currently in use, users attempting to gain access will be
given an opportunity to force a connection to the device if their preemption level
is equal to or higher than the current user's.
To switch to the active session from the local UI (local users only):
1. From the side navigation bar, select Local Session.
2. Select the Resume Active Session check box. The Video Viewer window will
appear.
-or-
Press Esc.
Configuring sessions
To configure general session settings:
1. From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Sessions > General. The Appliance General Session Settings
screen appears.
2. Select or deselect the Enable Inactivity Timeout check box.
3. In the Inactivity Timeout field, enter the amount of inactive time you want to
pass before the session closes (from 1 to 90 minutes).
590-1058-640A
3.3 KVM s4 Switch Sessions
25