Dns Settings; Local Ui Settings - Fujitsu Control 4 Serie Guia Del Usuario

3. Local and Remote Configuration
2. Select or deselect the Enable IPv6 Stateful Configuration check box to
enable or disable.
3. Enter the desired information in the Address, Gateway, and Prefix Length
fields.
4. Select either Enabled or Disabled in the DHCPv6 drop-down menu.
If you enable DHCPv6, any information that you enter in the Address, Gateway, and
Prefix length fields will be ignored.
5. Click Save.
3.6

DNS Settings

You can choose to either manually assign the DNS server or to use the
addresses obtained using DHCP or DHCPv6.
To manually configure DNS settings:
1. From the side navigation bar, select Unit View > Appliance > Appliance
Settings > DNS. The Appliance DNS Settings screen appears.
2. Select Manual, DHCP (if IPv4 is enabled) or DHCPv6 (if IPv6 is enabled).
3. If you selected Manual, enter the DNS Server numbers in the Primary,
Secondary and Tertiary fields.
4. Click Save.
3.7

Local UI Settings

To change how the local UI is invoked:
1. From the side navigation bar, select Unit View > Appliance > Appliance
Settings > Ports > Local Port UI to open the Local Port UI Settings screen.
2. Under the Invoke Local Port UI heading, select the check box next to one or
more of the listed methods.
3. Click OK.
Local port user settings
You can turn on or turn off local port user interface authentication and choose a
user access level. If you turn on local port user interface authentication, you will
be required to log in to use the interface.
30
590-1058-640A